Dynamic Towing Test Data Form
Date |
1994-12-21 |
Personnel |
B.L., B.R., & R.H. |
Temperature (°F) |
50 |
Humidity (%) |
58 |
Wind Direction |
SW |
Wind Speed (MPH) |
3 |
Barometer (in.Hg) |
30.2 |
Test Results
Inspect tow equipment-bus interface |
A safe and adequate connection was made between the tow equipment and the bus. |
Inspect tow equipment-wrecker interface |
A safe and adequate connection was made between the tow equipment (chains) and the wrecker. |
Towing Comments |
Tow chains were attached to the front axle and used to lift the vehicle. An 8" X 8" beam was placed under the frame to clear the undercarriage and a rubber pad was placed on the bumper to avoid damage. Manufacturer recommended a speed of 15 mph not be exceeded. |
Description and location of any structural damage |
None noted. |
General Comments |
The manufacturer recommends a flat tow incorporating a tow bar. A tow bar was not supplied, therefore, the above procedures were followed as per manufacturer. |
|
|
General
Check-In
Maintainability
Repair & Maintenance
Replacement & Repair
Reliability
Safety
Performance
Structural
Fuel Economy
Noise
Glossary
Back to Bus List
|