The Braun Corporation submitted a model 2002 GM Entervan III, gasoline-fueled, 5 seat/16-foot converted mini-van, for a 4 yr/100,000 mile STURAA test.  The odometer reading at the time of delivery was 128.0 miles.  Testing started on February 25, 2002 and was completed on April 30, 2002.  The Check-In section of the report provides a description of the bus and specifies its major components.


The primary part of the test program is the Structural Durability Test, which also provides the information for the Maintainability and Reliability results.  The Structural Durability Test was started on March 18, 2002 and was completed on April 12, 2002.


The interior of the test vehicle is configured with seating for 5 passengers and 1 handicap position including the driver.  At 150 lbs per person, this load results in a measured gross vehicle weight of 5,460 lbs.  The first segment of the Structural Durability Test was performed with the bus loaded to a GVW of 5,460 lbs.  The middle segment was performed at a seated load weight of 5,460 lbs and the final segment was performed at a curb weight of 3,110 lbs.  Durability driving resulted in unscheduled maintenance and failures that involved a variety of subsystems.  A description of failures, and a complete and detailed listing of scheduled and unscheduled maintenance is provided in the Maintainability section of this report.


Accessibility, in general, was adequate, components covered in Section 1.3 (Repair and/or Replacement of Selected Subsystems), along with all other components encountered during testing, were found to be readily accessible and no restrictions were noted.            


The Reliability section compiles failures that occurred during Structural Durability Testing.  Breakdowns are classified according to subsystems.  The data in this section are arranged so that those subsystems with more frequent problems are apparent.  The problems are also listed by class as defined in Section 2.  The test bus encountered no Class 1, 2 or 4 failures.  Of the two reported failures, both were Class 3.


The Safety Test, (a double-lane change, obstacle avoidance test) was safely performed in both right-hand and left-hand directions up to a maximum test speed of 45 mph.  The performance of the bus is illustrated by a speed vs. time plot.  Acceleration and gradeability test data are provided in Section 4, Performance.  The average time to obtain 50 mph was 13.35 seconds.


The Shakedown Test produced a maximum final loaded deflection of 0.067 inches with a permanent set ranging between 0.000 to 0.006 inches under a distributed static load of 3,075 lbs.  The Distortion Test was completed with all subsystems, doors and escape mechanisms operating properly.  No water leakage observed throughout the test.  All subsystems operated properly. 


The test vehicle was not equipped with any type of tow eyes or tow hooks, therefore, the Static Towing Test was not performed.  The Dynamic Towing Test was performed by means of a front-lift tow.  The towing interface was accomplished using a hydraulic-lift wrecker.  The bus was towed without incident and no damage resulted from the test.  The manufacturer does not recommend towing the bus from the rear, therefore, a rear test was not performed.  The Jacking and Hoisting Tests were also performed without incident. The bus was found to be stable on the jack stands, and the minimum jacking clearance observed with a tire deflated was 4.4 inches.


A Fuel Economy Test was run on simulated central business district, arterial, and commuter courses.  The results were 13.83 mpg, 15.10 mpg, and 26.25 mpg respectively; with an overall average of 16.34 mpg.


A series of Interior and Exterior Noise Tests was performed.  These data are listed in Section 7.1 and 7.2 respectively.





Number: 0206
Vin Number: 1GNDX03E62D121395