IC Bus/Champion Bus, Inc./General Coach American, Inc. Download PDF Report
IC Bus/Champion Bus, Inc./General Coach America, Inc., submitted an AC Series/Challenger/Defender/American Coach. The test bus is a diesel-powered 29 seat (including the driver) 33 foot bus, and was submitted for a 7 yr/200,000 mile STURAA test. The odometer reading at the time of delivery was 833 miles. Testing started on August 8, 2011 and was completed on June 28, 2012. The Check-In section of the report provides a description of the bus and specifies its major components.
The primary part of the test program is the Structural Durability Test, which also provides the information for the Maintainability and Reliability results. The Structural Durability Test was started on August 17, 2011 and was completed on June 25, 2012.
The interior of the bus is configured with seating for 29 passengers including the driver. Free floor space will accommodate 21 standing passengers resulting in a potential load of 50 persons. At 150 lbs per person, this load results in a measured gross vehicle weight of 21,800 lbs. Note; at Gross Vehicle Load (GVL) the weight of the front axle is 220 lbs over the front GAWR, the weight of the rear axle is 1,080 lbs over the rear GAWR and the total weight is 2,300 lbs over the GVWR. The first segment of the Structural Durability Test was performed with the bus loaded to a GVW of 21,800 lbs. The middle segment was performed at a seated load weight of 19,920 lbs and the final segment was performed at a curb weight of 15,060 lbs. Durability driving resulted in unscheduled maintenance and failures that involved a variety of subsystems. A description of failures, and a complete and detailed listing of scheduled and unscheduled maintenance are provided in the Maintainability section of this report.
Effective January 1, 2010 the Federal Transit Administration determined that the total number of simulated passengers used for loading all test vehicles will be based on the full complement of seats and free-floor space available for standing passengers (150 lbs per passenger). The passenger loading used for dynamic testing will not be reduced in order to comply with Gross Axle Weight Ratings (GAWR’s) or the Gross Vehicle Weight Ratings (GVWR’s) declared by the manufacturer. Cases where the loading exceeds the GAWR and/or the GVWR will be noted accordingly. During the testing program, all test vehicles transported or operated over public roadways will be loaded to comply with the GAWR and GVWR specified by the manufacturer.
Accessibility, in general, was adequate, components covered in Section 1.3 (Repair and/or Replacement of Selected Subsystems) along with all other components encountered during testing, were found to be readily accessible and no restrictions were noted.
The Reliability section compiles failures that occurred during Structural Durability Testing. Breakdowns are classified according to subsystems. The data in this section are arranged so that those subsystems with more frequent problems are apparent. The problems are also listed by class as defined in Section 2. The test bus encountered no Class 1 failures. Of the 8 reported failures 1 was a Class 2, 5 were Class 3 and 2 were class 4.
The Shakedown Test produced a maximum final loaded deflection of 0.318 inches with a permanent set ranging between -0.006 to 0.006 inches under a distributed static load of 19,350 lbs. The Distortion Test was completed with all subsystems, doors and escape mechanisms operating properly. No water leakage was observed throughout the test. All subsystems operated properly.
The submitted test bus was not equipped with any type of tow eyes or tow hooks, therefore the Static Towing Test was not performed. The Dynamic Towing Test was performed by means of a front-lift tow. The towing interface was accomplished using a hydraulic under-lift wrecker. The bus was towed without incident and no damage resulted from the test. The manufacturer does not recommend towing the bus from the rear, therefore, a rear test was not performed. The Jacking and Hoisting Tests were also performed without incident. The bus was found to be stable on the jack stands, and the minimum jacking clearance observed with a tire deflated was 4.8 inches.
A Fuel Economy Test was run on simulated central business district, arterial, and commuter courses. The results were 4.95 mpg, 5.23 mpg, and 10.17 mpg respectively; with an overall average of 5.91 mpg.
A series of Interior and Exterior Noise Tests was performed. These data are listed in Section 7.1 and 7.2 respectively.
The Emissions Test was performed. These results are available in Section 8 of this report.